Valves, Orifices, and Manifolds for Thermos grills

Brass spud orifice with 5/16” x 32 thread size for some Thermos grills. Has #70 starter hole. Must be drilled to proper drill size.

If you would like us to drill the orifice(s) for you, there is a single $15 fee for this service, which will be added to the order when processed. Please tell us the number of burners in your grill and the total BTUs of your grill (less side burner and rotisserie burner, if any). BTU rating information can usually be found on the grill's CSA certification tag, located somewhere on the grill. Please furnish this, along with any other information you deem relevant, in the Message to CLA box during checkout.

Part Number: 31600
Dimensions: 0 3/8” x 0 7/16”
Material: brass
Weight: 0.01

Brass spud orifice with 11/32” x 32 thread size for some Thermos grills. Has #70 starter hole. Must be drilled to proper drill size.

If you would like us to drill the orifice(s) for you, there is a single $15 fee for this service, which will be added to the order when processed. Please tell us the number of burners in your grill and the total BTUs of your grill (less side burner and rotisserie burner, if any). BTU rating information can usually be found on the grill's CSA certification tag, located somewhere on the grill. Please furnish this, along with any other information you deem relevant, in the Message to CLA box during checkout.

Part Number: 33200
Dimensions: 0 7/16” x 0 7/16”
Material: brass
Weight: 0.01

Valve with 45° angled orifice snout built to accept 11/32 x 32 threaded spud type orifice (not provided); uses orifice # 33200 for some Thermos grills. Mounts to the right side of original up-front control manifold assembly. Valve stem is 8mm, and needs a knob with a 9 D-value. Can use with universal knobs 00110 or 00310 or 01800 depending on needed knob stem length.

Part Number: 38600
Dimensions: 3 9/16” x 1 1/4”
Material: brass
Weight: 0.4

Dual brass LP valve assembly for some Thermos grills. Includes left and right control valves and valve manifold. Fits Arkla up-front control grills and others requiring 45 degree angle valves.

• For use with LP gas
• Includes two orifices drilled to #57 drill size
• Includes pre-assembled 45 degree angle fitting, not shown in photo

Made in USA

Part Number: VLV-28
Material: brass
Weight: 1.1