Rotisserie components for Martha Stewart grills

Plastic spit rod handle with brass insert for some Martha Stewart grills.

• Requires bushing BU-1 (5/16” square spit rods) or BU-2 (3/8” square spit rods)
• Will fit our spit rods: SR-5; SR-8; SR-43
• Requires a threaded end on the spit rod
• The mounting hole in the handle is 3/8-16 coarse thread female

Part Number: PH-1
Weight: 0.2

Universal rotisserie kit for some Martha Stewart grills. THIS KIT INCLUDES AN INVERTED MOTOR BRACKET THAT POSITIONS THE MOTOR INVERTED. Includes:

• R06 stainless steel motor
• SR-5 31” X 5/16” spit rod
• BU-1 spit rod bushing
• PH-1 spit rod handle
• MH-1B Chrome-plated meat forks
• MB-3B Inverted motor mounting bracket and screws
• MB-2B Rotisserie bushing bracket (for grills with no bushing notch in casting)
• Maximum 25 lbs. balanced load

Fits grills with hoods up to 26 inches wide. Be sure to measure before ordering.

Note: The pre-drilled mounting holes in the MB-3B rotisserie motor mounting bracket are designed to accommodate existing hole patterns approximately 1 3/8” apart. It is possible that you may have to drill new holes.

NOTE: This kit does NOT include spit counter balance, which should be used to insure even weight distribution.

NOTE: Some of the parts in the kit are designed for a 5/16” rod. Rod SR-43, which is a 3/8” square rod, will not work with some of the parts in this kit.

Part Number: RK-MHP
Weight: 4.6

Universal durable battery operated rotisserie motor for some Martha Stewart grills. Conveniently eliminates the need for electric cords. Runs on 2 D cells (not included).

Part Number: RO-4
Weight: 1.0